6. WHAT TO DO IF...
WARNING!
Before troubleshooting, discon-
nect the mains plug from the
mains socket.
Only a qualified electrician or com-
petent person must do the trou-
bleshooting that is not in this man-
ual.
Problem
The appliance is
noisy
The appliance does
not operate. The
lamp does not oper-
ate.
The lamp does not
work.
The compressor op-
erates continually.
The compressor
does not start im-
mediately after
pressing the Shop-
pingMode switch, or
after changing the
temperature.
Possible cause
The appliance is not sup-
ported properly
The appliance is switched
off.
The mains plug is not con-
nected to the mains sock-
et correctly.
The appliance has no
power. There is no voltage
in the mains socket.
The lamp is in stand-by.
The lamp is defective.
The temperature is not set
correctly.
The door is not closed
correctly.
The door has been
opened too frequently.
The product temperature
is too high.
The room temperature is
too high.
This is normal, no error
has occurred.
ENGLISH
Solution
Check if the appliance
stands stable (all the four
feet should be on the floor)
Switch on the appliance.
Connect the mains plug to
the mains socket correctly.
Connect a different electri-
cal appliance to the mains
socket.
Contact a qualified electri-
cian.
Close and open the door.
Refer to "Replacing the
lamp".
Set a higher temperature.
Refer to "Closing the door".
Do not keep the door open
longer than necessary.
Let the product tempera-
ture decrease to room tem-
perature before storage.
Decrease the room temper-
ature.
The compressor starts after
a period of time.
13