Disposal; To Discard The Product; Troubleshooting; To Do Troubleshooting Of The Product - Menuett SOUS VIDE Traduction Des Instructions D'origine

Circulateur
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 34
6

Disposal

6.1 To discard the product

Make sure that you follow local regulations when you
discard the product. Do not burn the product.

Troubleshooting

6.2 To do troubleshooting of the
product
Caution! Do not repair the product, the product must
be repaired at an approved service center.
Problem
Too little water. 3 warning
sounds are given and the
error message "ER1" is
shown on the control
panel.
The product overheats. 3
warning sounds are given
and the error message
"ER2" is shown on the
control panel.
7

Technical data

Technical data
Rated voltage
Power output
Noise level
Dimensions
23
Action
Fill with water until the
water level is in between
the minimum and
maximum markings on the
product. If the error
message does not go off,
speak to an approved
service center.
Disconnect the power plug
and let the product
become cool before you
operate the product again.
Make sure that the water
level is between the
minimum and maximum
markings on the product.
Fill with water if it is
necessary. If the error
message does not go off,
speak to an approved
service center.
230 V ~ 50 Hz
1000 W
55 dB
380x Ø 60 mm
2022_001

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

005527

Table des Matières