KWC ERA 810-34 Manuel D'installation Et D'entretien page 16

EN
Warning
1. Do not install the bowl in the wooden
worktops.
2. In case of net support underneath the
worktop (comon for ceramic), grind the net
away in the corners of the cutout to let the
brackets glue properly.
3. Paper tape masking is suggested, especially in
case of white color worktop or porous materials.
Installation
1. Degrease with special wipes provided in the
indicated areas, inside the cut and under the
worktop.
2.1 Apply the primer under the worktop with
the appropriate 4 single-dose cigarettes.
2.2 Break the inner vial to moisten the swab.
2.3 Apply in the indicated areas. One for the
corner.
3.1 Fix adjustable supports.
3.2 Align the start of the cutout radius.
3.3 Make contact.
3.4 Apply a certain pressure for a few seconds.
4. Slightly unscrew the nuts with the supplied
keylock.
5. Insert the bowl into the hole by centering the
supports.
6.1 Align the bowl with the worktop with the
appropriate keylock.
6.2 Make sure that the bowl and top are
perfectly aligned!
7. Apply the spacers to center the bowl in the
hole. Be careful that the gap between the bowl
and the hole is even all around.
8.1 Apply MS glue on the long brackets.
8.2 Place the brackets with the glue in contact
16
with the bowl and the worktop as indicated.
9. Wait at least 30 minutes, until the glue has
taken hold.
10. Apply MS glue for sealing along the gap
between the bowl and the hole in the worktop.
MS provided with installation kit is black. Any
different color, wich may be prefered for a better
matching with the color of the worktop, should
be purchesed separate.
WARNING! Black MS could stain the worktop
in case of worktop in poruos material and light
color. In this case mask the worktop with tape
before sealing or use a different color for MS.
11. Remove excess MS glue with special spatulas
and clean with the special wipes provided.
Removal
1. Remove the movable part of the brackets.
2. Detach the bracket from the bowl with a
hammer and a screwdriver or something similar.
3. Cut with a sharp cutter the sealing between
top and bowl.
4. Detach the brackets from the top with a
hammer and a screwdriver or something similar.
* optional
www.kwc.com/intop
KWC | 993.0529.918 | 01/18