Specifi Cation - GRAUPNER SJ Ultra Twin 40 Instructions D'utilisation

Battery:
Charge current / power
Ni-Cd & Ni-MH batteries:
Cell count
Lithium batteries:
Cell count
Cell voltage
General:
Operating voltage range DC input:
Operating voltage range AC input:
Car battery required:
Mains PSU required:
Idle current:
Low-voltage cut-off approx.
Balancer connector:
Balancer current max. approx.:
Safety timer:
Trickle charge:
Weight approx.
Dimensions approx. (WxDxH)
All data assumes a car battery voltage of 12.5 V.
The stated values are approximate only; they may vary depending on the state of the battery being charged, temperature etc.
1)
When powered by a mains PSU, the charger will only operate correctly if the PSU is suitable in terms of voltage, stability, maximum load capacity etc. You can avoid problems by using only the PSUs
which we specifi cally recommend.
38
16. Specifi cation
2x 800 mA, 1.5 A, 3 A, 5.0 A / max. 40 W with internal power supply 100~240 V AC
2x 800 mA, 1.5 A, 3 A, 5.0 A / max. 40 W with external 11...15 V DC power supply
(max. 80 W total)
4 - 8 cells
 peak 5 mV/cell
1 - 3 cells
3,3 V (LiFe), 3,6 V (LiIo), 3,7 V (LiPo)
11.0 to 15 V
100 ~ 240 V
12 V, min. 60 Ah
12 - 14V, min. 10 A stabilised
approx. 160 mA
10.7 V
1...3 LiPo/LiIo/LiFe cells
0.2 A LiPo/LiIo/LiFe
90 min.
50/100/150/250 mA automatic
720 g
205 x 165 x 57 mm
1)
Manual ULTRA TWIN 40