Star Ultra-max 824MA Instructions D'installation Et D'opération page 7

PILOT FLAME ADJUSTMENT
The griddles are equipped with standing pilots and should be lit immediately after the gas is turned on.
MANUAL VALVE AND THROTTLING CONTROL MODELS
Adjust the flame as low as possible while still providing immediate burner ignition when the control
knob is turned to high.
LIGHTING INSTRUCTIONS
When the griddle is first lit, it will smoke until the preservative oils and impurities are burned off.
The griddles are equipped with standing pilots and should be lit immediately after the gas is turned
on. Snap Action giddles do not have a standing pilot and do not require lighting. The Unit should
be properly leveled prior to lighting, with the rear of the griddle slightly higher than the front to allow
grease to roll off and flue gasses to escape out the rear..
DO NOT ATTEMPT TO LIGHT YOUR PILOT BURNER IF YOU EXPERIENCE A
STRONG GAS ODOR.
CAUTION
MANUAL VALVE AND THROTTLING CONTROL MODELS
1. Turn off the main valve to the unit and wait 5 minutes to clear gas.
2. Turn off all knobs and pilot valves.
3. Turn on main valve to unit and light all pilots.
4. Turn burner knobs to desired position.
5. To turn burners off, turn knobs to off.
ORIFICE ELEVATION COMPENSATION CHART
Orifice @ sea level 2000
NAT 41
LP 52
Thermostatic Conrol Gas Griddles: 824TA thru 872TA
NAT 38
LP 52
3000 4000 5000
Manual Control Gas Griddles: 824ma thru 872MA
42 42 42 43
52 53 53 53
39 40 41 41
52 53 53 53
7 7
6000 7000 8000 9000
43 44 44 45
53 53 54 54
42 42 43 43
53 53 54 54
10000
46
54
44
54