Star Ultra-max 824MA Instructions D'installation Et D'opération page 5

LEVELING UNIT
This griddle is supplied with 4 feet or floor stand legs which must be screwed into the body. After
the griddle is in its final position, adjust the legs to create 1/8 inch slant from back to front. This will
allow the grease to run into the grease gutter and provide the proper combustion air for the burners.
Adjusting the (4) feet which have an adjustment of 1-3/4" for accurate and perfect line-up with other
units.
DO NOT INSTALL WITHOUT ATTACHING FEET OR SUPPLIED STAND LEGS
AND SHELF - DO NOT REMOVE FEET.
CAUTION
ON OPTIONAL EQUIPMENT STAND
Caster Kits: Casters can be used with floor
stand models or optional equipment stand.
For installation, carefully mark and cut off from
the bottom of each leg using a straight cutting
saw and de-burr the inside tube wall prior to
installing the caster. Cut leg should measure
19" tube length, not overall length. Casters
add about 6-1/4" of height to the unit. Be
sure to use approved strain relief means for
protecting gas line connection. If an appliance
is equipped with casters and is gas connected
with a quick connect coupling, all personnel
must be aware that there is a restraint on the
appliance and if disconnected for service or
cleaning it must be reconnected as originally
installed prior to use.
COUNTER TOP MODEL
MOUNTING NUTS ON BOTTOM
STIFFENING SUPPORTS FOR
860 & 872 MODELS ONLY
FLOOR STAND SHELF
FLOOR STAND MODEL
5 5
SCREW LEGS INTO
IL2586