Télécharger Imprimer la page

Bosch FAA-420-RI Notice D'installation page 6

Indicateur à distance

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 8
6
en
NOTICE!
The FAA-420-RI remote indicator must be installed such that the
broad side of the red alarm indication (see Figure 1 a, pos. B)
follows the observer's line of sight.
WARNING!
If the maximum current consumption of the connected detector
is larger than 20 mA, it can result in malfunctions and damage
to the Remote Indicator.
In order to prevent damage to the device, ensure that the
maximum current consumption of 20 mA is not exceeded.
Bosch point-type detectors already have an internal resistance
which limits the current consumption.
Installation
1.
Before assembly, remove the cap from the base plate: Unlock the snap-
fit hook (see Figure 1 a, pos. C) with a flat object (e.g. screwdriver),
press in and lift the cap carefully.
2.
Mount the FAA-420-RI directly on the ceiling or wall. Secure the base
plate on an even, dry foundation with two (see Figure 2, pos. E) or with
four (pos. F) screws.
3.
For surface-mounted cable insertion, break out the pre-punched cable
feeds (see Figure 1 b, pos. D) on any side of the housing. For flush-
mounted cable insertion, the cable is fed in through the opening
beneath the connection board (see Figure 2, pos. G).
4.
Connect the FAA-420-RI via two terminals (see Figure 3).
5.
Place the housing on the base plate so that the two hooks (see
Figure 1 a, pos. A) are inserted into the two slits. Press the cap slightly
onto the base plate until the snap-fit hook (pos. C) engages.
Technical Data
Operating voltage
Weight
Display medium
Permissible wire gauge
Maximum current consumption
F.01U.025.792 | 2.0 | 2009.11
5–30 V DC
45 g
2 LEDs
0,6–2 mm
20 mA
Bosch Sicherheitssysteme GmbH
FAA-420-RI

Publicité

loading

Ce manuel est également adapté pour:

F.01u.522.590