Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 75
User manual and warranty card
THE CUTTING UNIT CABINET
Warning! When the engine is running, the cutting blades rotate.
1. After finishing work, thoroughly clean the entire device.
2. Stop the engine and disconnect the spark plug wire before cleaning the housing.
3. Empty the fuel tank before cleaning.
4. Without tilting the mower to the side, lay it on the ground so that the front wheels are in the air.
5. Clean the underside of the mower with a brush and water.
Do not use high-pressure cleaning devices, as high-pressure water can break the paint protection of
the housing. Do not use intensive cleaning and washing agents, e.g. aggressive detergents, they can
damage plastics and metals, which may result in deterioration of the device's safety.
After connecting the hose to a special quick coupler that is already mounted in the mower housing
and unscrew the water, start the mower. The device is cleaned during the rotation of the knife, on
which a strong stream rinses out flushing residues of grass. (Fig. 13)

MAINTENANCE

HANDLING THE CUTTING KNIFE
Warning:
Disconnect the spark plug wire before checking the cutting knife or blade attachment shaft. If the
knife hits an object, stop the engine, disconnect the spark plug cable and check the mower for
damage. Check whether the crankshaft on the power take-off side or the adapter to which the knife
is attached has not been damaged (bent or cracked).
The knife adapter does not provide protection against engine damage when the knife hits objects
other than grass, e.g. stones, branches, molehills.
Check often that the knives are not bent, that they are not excessively worn, and that there are no
other damages such as cracks or deformations.
Damaged parts must be replaced with new ones, recommended by the manufacturer. For safety,
replace the knives every two years. Knives should be well sharpened (details in chapter "Sharpening
a knife"). Blunt knives tug at the grass, causing the tips to yellow.
Attention! It is imperative to balance the knife after each sharpening. An unbalanced blade
can cause dangerous vibrations that can damage the mower and / or cause an accident.
Check the knife clamping screw often. The screw must be firmly tightened to a torque of 45 to 55
Nm.
REMOVING THE KNIFE (Fig. 14A)
1. Addapter
2. Knife
3. Saddle half pad
4. Screw
Attention! Cutting knife 2 (Fig. 14A) it can be very sharp, use gloves to protect your hands
against injury.
1. Empty the fuel tank.
2. Use a wooden block to prevent the knife from turning.
21
English

Publicité

Table des Matières
loading

Table des Matières