Safety Recommendations - EUROM FLOW SP400i Instructions De Service

Safety recommendations

Before using your new pump, check it, including cord and plug, for

any visible damage. Do not use a damaged pump, but send it back
to your dealer for replacement.
For safety reasons, your submersible pump must always be

connected to an earthed socket that has been installed according to
national regulations, forms part of an electricity network that is
equipped with a fuse of at most 16 Amp and has an earth leakage
circuit breaker (nominal voltage ≤30 mA).
Check your pump, electrical cable, plug and socket before each use.

Do not use if the device is damaged and have this damage repaired
by an accredited electrician.
Ensure that electrical connections stay dry at all times. Do not touch

them with wet hands.
Before use, ensure that the socket to which you are connecting the

pump is suitable for the pump itself (see type plate).
Protect the electrical cable and plug from heat, oil and sharp corners.

Clean the drainage pipe before use.

Before use, check to ensure that elevation height does not exceed

your pump's capacity.
Do not use the electrical cable to hang up, lower or move the pump.

Attach a rope to the handle in order to do this. Never pull on the
cable to remove the plug from the socket but remove by pulling on
the plug!
Rinse the pump with clean water if you have used it to pump water

that contains chlorine, for example, or deposits. Bear in mind that
sand and all other abrasive and corrosive substances will increase
wear and tear and impact upon the effectiveness of the pump.
Ensure the pump is not used if it cannot drain off the water due to

issues such as blocked drainage, elevation too high, etc. This will
damage the pump!
Do not use the pump if there are persons present in the object to be

pumped out. It is forbidden to use this pump in a swimming pool.
Allowing the pump to run dry will increase wear and tear and cause

overheating. Always prevent the pump from running if no water is
being moved and switch it off immediately if this is the case.
Before you carry out checking or cleaning tasks on the pump you

must switch it off by removing the plug from the socket.
13