Table Des Matières - Stanley 71501 Manuel

O R I G I N A L I N S T R U C T I O N
©2021 STANLEY Black & Decker
All rights reserved.
The information provided may not be reproduced and/or made public in any way and through any means (electronically or
mechanically) without prior explicit and written permission from STANLEY Engineered Fastening. The information provided
is based on the data known at the moment of the introduction of this product. STANLEY Engineered Fastening pursues a
policy of continuous product improvement and therefore the products may be subject to change. The information provided
is applicable to the product as delivered by STANLEY Engineered Fastening. Therefore, STANLEY Engineered Fastening
cannot be held liable for any damage resulting from deviations from the original specifications of the product.
The information available has been composed with the utmost care. However, STANLEY Engineered Fastening will not
accept any liability with respect to any faults in the information nor for the consequences thereof. STANLEY Engineered
Fastening will not accept any liability for damage resulting from activities carried out by third parties. The working names,
trade names, registered trademarks, etc. used by STANLEY Engineered Fastening should not be considered as being free,
pursuant to the legislation with respect to the protection of trademarks.
CONTENT
1. SAFETY DEFINITIONS ................................................................................................................................................... 4
1.1 GENERAL SAFETY RULES .......................................................................................................................................................................... 4
1.2 PROJECTILE HAZARDS .............................................................................................................................................................................. 4
1.3 OPERATING HAZARDS ............................................................................................................................................................................... 5
1.4 REPETITIVE MOTIONS HAZARDS............................................................................................................................................................ 5
1.5 ACCESSORY HAZARDS .............................................................................................................................................................................. 5
1.6 WORKPLACE HAZARDS ............................................................................................................................................................................. 5
1.7 NOISE HAZARDS .......................................................................................................................................................................................... 5
1.8 ADDITIONAL SAFETY INSTRUCTIONS FOR HYDRAULIC POWER TOOLS ................................................................................. 5
2. SPECIFICATIONS ............................................................................................................................................................ 7
2.1 INTENT OF USE ............................................................................................................................................................................................. 7
2.2 TOOL SPECIFICATION ................................................................................................................................................................................. 7
2.3 TOOL DIMENSIONS ..................................................................................................................................................................................... 7
3. PUTTING IN SERVICE..................................................................................................................................................... 8
4. OPERATING INSTRUCTIONS ......................................................................................................................................... 8
5. SERVICING THE TOOL.................................................................................................................................................... 8
5.1 DAILY SERVICING ......................................................................................................................................................................................... 8
5.2 WEEKLY SERVICING ..................................................................................................................................................................................... 8
5.3 ANNUAL SERVICING / EVERY 500K OPERATIONS ............................................................................................................................ 8
5.4 SERVICE KIT ................................................................................................................................................................................................... 9
5.5 HYDRAULIC OIL ........................................................................................................................................................................................... 9
5.6 DISMANTLING INSTRUCTIONS ............................................................................................................................................................... 9
5.7 PROTECTING THE ENVIRONMENT .......................................................................................................................................................10
6. GENERAL ASSEMBLY AND PART LIST ........................................................................................................................ 11
6.1 GENERAL ASSEMBLY ................................................................................................................................................................................11
6.2 PARTS LIST ...................................................................................................................................................................................................11
7. SAFETY DATA .............................................................................................................................................................. 12
7.1 HYSPIN VG32 OIL SAFETY DATA ...........................................................................................................................................................12
7.2 MOLYLITHIUM GREASE EP 3753 - SAFETY DATA ............................................................................................................................12
7.3 MOLYKOTE® 111 GREASE - SAFTEY DATA .........................................................................................................................................13
8. EC DECLARATION OF INCORPORATION OF PARTLY COMPLETED MACHINERY ..................................................... 14
9. UK DECLARATION OF INCORPORATION OF PARTLY COMPLETED MACHINERY ................................................. 15
10. PROTECT YOUR INVESTMENT! ................................................................................................................................... 16
E N G L I S H
3