Leister HOTWIND PREMIUM Notice D'utilisation page 23

Changing the nozzle or reflector
Danger – can cause burns ! Do not touch the heating element tube and nozzle while they are hot.
Switch off the main switch (2)
reflector.
Machine switches off automatically.
Installation
• The device may only be installed by trained personnel.
• For installation dimensions, see page 3, dimensions/size.
Prior to installation of the device, switch off the unit by the main switch (2)
to cool down. Machine switches off automatically.
120
Disconnect power supply cord (1) form the line/mains.
230
• It must be ensured that the connection lines do not come into contact with the heating element tube and are not
exposed to the hot air jet.
• The device must be fastened with three M5 screws to the thread inserts.
• The installation must ensure that
– only cold air is supplied
– no excess (heat) residue builds up
– the device is not subject to jets of hot air from another device.
• If the air contains dust use a Leister stainless steel filter (see accessories) and push it on the air inlet flange (6).
• In the case of particularly critical dusts (e.g. metal, electrically conductive or damp dusts), special filters must be
used to avoid short-circuits in the device.
• Protect the device from mechanical vibrations and shocks.
Operation
• Mount corresponding nozzle or reflector, if required.
It must be ensured that the hot air can flow out freely, as otherwise the device can be damaged by the
excess heat building up (risk of fire !).
Connect power supply cord (1) to the electrical mains. The nominal voltage indicated on the device
120
must correspond to the mains voltage.
230
• Switch on main switch (2)
After heating mode, switch off the unit by the main switch (2)
Machine switches off automatically.
120
Disconnect power supply cord (1) form the line/mains.
230
• WARNING: When using as a built-in unit, a suitable device for full disconnection from the mains with a contact
distance of 3 mm must be provided in the mains connection.
and allow the unit to cool down before replacing the nozzle or
and allow the device
and allow the device to cool down.
23