Publicité
Les langues disponibles
Les langues disponibles
Highlighting and Selecting Menu Items
To navigate On-screen Menus, use the
RIGHT
keys.
Press
ENTER
key to change the menu. For some products,
pressing the
ENTER
key while in Menu Mode returns you
to the previous menu.
Notes:
All functions in competitive models and brands of products
may not be fully supported.
The remote will automatically time out in Menu Mode after
approximately 10 seconds of inactivity (no keys being
pressed). For DVD menus, the Menu Mode will time out after
approximately 15 seconds.
Because of the wide variety of menu formats, some
experimenting may be required.
Exiting a Menu System
To exit Menu Mode, press and release
remote.
Troubleshooting
Problem: The remote cannot be programmed to operate
your component.
You may be too far from the component or at a
wrong angle. This remote uses IR (infrared) technology to
communicate with components. The remote sends the code
and the component's IR sensor reads the code.
Therefore, there must be an unobstructed path between the
remote and the IR sensor of the component. Move closer and
make sure you point the remote at the component (VCR
when programming the
VCR
TV
key, etc.)
If you've entered all of the codes for your brand that are in the
accompanying Code List and followed the instructions, try the
Code Search method.
You must put the remote in the correct mode by pressing the
corresponding component key, so the remote knows which
component you want to operate.
Problem: The indicator light does not light when you
press a key.
You must put the remote in the correct mode by pressing the
corresponding component key so the remote knows which
component you want to operate.
You may have pressed the invalid key for the mode the
remote is in (for example,
Make sure the batteries are properly installed.
Replace the batteries with two new AA batteries.
Reprogramming may be required.
8
UP/DOWN/LEFT/
MENU
key on the
key, TV when programming the
REC
only works in VCR mode).
Publicité
