Jumbo URC-151 Mode D'emploi page 6

Code Search Methods
If your component's brand isn't listed in the Code List or you
have tried all of the codes for your brand and the remote does
not operate your component, use the Code Search Method
below - Manual Code Search. The Manual Code Search
method searches all the codes because your component's
code may be listed under another brand in the code list.
Note: The Code Search method may take a long time
because the remote searches all of the codes in its memory
for the code which operates your component. Therefore, if
your brand is listed in the Code List, use the Direct Entry
method.
Manual Code Search
1. Manually turn on the component you
CODE INDICATOR
SEARCH LIGHT
want your remote to operate.
2. Press and hold the
key until the indicator light comes on.
Then release the
3. Press and release the component key
CABLE TV VCR DVD SAT
that corresponds to the component you
want the remote to operate. The
indicator light will blink and then
remains lit.
(BLINK)
4. Aim the remote at the component and
press the ON/OFF key slowly and
repeatedly until the component turns
off. Make sure the indicator light will
blink once each time you press
ON OFF
ON/OFF button.
Important:
codes, you may have to press the
ON/OFF key many times - possibly
up to 200 times.
ENTER
5. When the component turns off, press
the
6. Use Code Retrieval on the next page
to identify the code for your component
for future reference.
Code Retrieval
If you used the Code Search methods to program your
remote, follow the steps below to find out which code is
compatible with your component. Finding the actual code and
writing it down will save your time if you ever need to program
the remote again (e.g., if programming is lost when you
change the batteries).
1. Press and hold the
CODE INDICATOR
SEARCH LIGHT
key until the indicator light comes on.
Then release the
2. Press and release the component key
that matches the component's code you
CABLE TV VCR DVD SAT
are retrieving (TV, VCR, DVD, Satellite
or Cable). The indicator light will blink
once and then remains lit.
(BLINK)
3. Press and release the
key. The indicator light turns on.
4. Starting with
CODE
press the number keys in order (
SEARCH
5. The number that causes the indicator
OFF
light to blink is the first digit of your
code.
6. Repeat step 4 until you have retrieved
1 2 3
all three numbers of the code.
4 5 6
7. Once you have found the third number,
the LED turns off.
7 8 9
0
6
CODE SEARCH
CODE SEARCH
Because there are so many
ENTER key to store the code.
CODE SEARCH
CODE SEARCH
CODE SEARCH
0 first on the key pad,
0-9
key.
key.
).