Jumbo URC-151 Mode D'emploi page 4

Program for DVD - Direct Entry Method
In order for the universal remote to control your DVD player,
you must program it with the code that matches your
component. The DVD key can be programmed to operate a
DVD player. These instructions explain the preferred method
of programming the remote - the Direct Entry Method:
1. Manually turn on the DVD player.
2. Locate the enclosed DVD Code List.
Note:
the manual Code Search methods
CODE INDICATOR
to program this remote control.
SEARCH LIGHT
3. Press and hold the
key until the indicator light comes on.
Then release the
4. Press and release the
DVD (BLINK)
indicator light will blink.
5. Use the number keys on the remote
to enter the first code listed for your
brand.
After you entered a three-digit code,
CABLE TV VCR DVD SAT
the indicator light turns off.
Note:
LED will flash rapidly for 2 seconds.
Start over at step 3.
1 2 3
6. Aim the remote at your component and
4 5 6 press the ON/OFF key. If your DVD
turns off, you have found the correct
7 8 9
(OFF)
code.
0
7. Enter the code in the box provided on
this page for future reference.
8. If your component doesn't turn off,
repeat steps 3-6 above, entering the
ON OFF
next code for brand.
If none of the codes work or your brand
is not listed, use other Code Search
methods to program this remote.
DVD CODE
4
If your brand isn't listed, use
CODE SEARCH
CODE SEARCH
key.
DVD key. The
If you enter an invalid code, the