Publicité
GENERAL INFORMATION
This equipment is designed and sold for commercial
use only by personnel trained and experienced in its
operation and is not sold for consumer use in and
around the home nor for use directly by the general
public in food service locations.
First and foremost, each crate should be examined
before signing the Bill of Lading to report any visible
damage by the trucker in transit and to account for the
proper number of crates. If there is apparent damage,
arrangements should be made to fi le a claim against the
carrier. Interstate Commerce Regulations require that
the claim must be initiated by the consignee. Proper
and secure storage facilities should be arranged for
the oven(s) if necessary to protect it from outdoor or
damp conditions at all times before installation.
-IMPORTANT-
When you have all the crates unloaded, open the
crates and remove all plastic covers. Inspect at
once for concealed damage. If anything appears
to be damaged, contact the appropriate persons
immediately to fi le a damage claim. After completing
this inspection, fi nish unpacking the oven. Be sure
to remove all paper protection and packing material
from the unit prior to lighting.
CAUTION
FOR YOUR SAFETY DO NOT STORE OR USE
GASOLINE OR OTHER FLAMMABLE VAPORS
AND LIQUIDS IN THE VICINITY OF THIS OR
ANY OTHER APPLIANCE.
The installation of the Appliance must conform to
"ANSI Z223.1 - LATEST EDITION" AND ALL LOCAL
GAS COMPANY RULES AND REGULATIONS.
IN CANADA INSTALLATION SHALL BE IN
ACCORDANCE WITH THE CURRENT CAN/
CGA-B149.1 NATURAL GAS INSTALLATION
CODE OR CAN/CGA-B149.2 PROPANE
INSTALLATION CODE AND LOCAL CODES
WHERE APPLICABLE.
This appliance must be installed with a stand and
casters designed by Star Manufacturing as part of a
complete installation. The installation must also include
a connector complying with either ANSI Z21.69 or CAN/
CGA-6.16 and a quick-disconnect device complying
with either ANSI Z21.41 or CAN1-6.9. It must also
be installed with restraining means to guard against
transmission of strain to the connector as specifi ed
in the appliance manufacturer's instructions.
For your protection, we recommend a qualifi ed
installing agency install this appliance in
accordance with the rules in force within
the country of destination. They should be
familiar with gas installations and your local
gas requirements. In any case, your gas
company should be called to approve the
fi nal installation.
This appliance, its pressure regulator, and its individual
shutoff valve must be disconnected from the gas
supply piping system during any pressure testing of
that system at test pressures in excess of 1/2 PSIG.
This appliance and its pressure regulator must be
isolated from the gas supply piping system by closing
its individual manual shutoff valve during any pressure
testing of the gas supply piping system at test pressures
equal to or less than 1/2 PSIG.
PURCHASER'S RESPONSIBILITY
It is the responsibility of the purchaser:
1. To see that the gas and electric services for
the oven are installed on site in accordance
with the manufacturer's specifi cations.
2. To unload, uncrate, and install the oven in its
proper location and in accordance with this
installation operation manual.
3. To see that all gas and electric services are
connected properly by a qualifi ed installer
of your choice. All such connections must
be in accordance with applicable code
requirements.
4. To arrange for inspection and operation check-
out by an authorized service technician. The
warranty becomes effective upon verifi cation
of proper installation.
4
NOTICE
Publicité
