Publicité
Les langues disponibles
Les langues disponibles
!
!
19
CAUTION! Always make sure the compressor's power switch (1) is in its "OFF"
position and power cord is unplugged prior to performing any service, maintenance,
or cleaning of the compressor.
HOSE CONNECTION
Attach an air hose to the compressor's air outlet (7) with the ¼" female connector
already attached. Then set the desired pressure to operate your tool (See "To
adjust the air regulator" below). Next, connect the air hose to the tool's air inlet. Use
sealing tape for best air-tight connections.
OPERATING PROCEDURES
To Start The Compressor: (FIG B.)
Check to make sure the air tank's drain valve (8), located at the bottom of the
air tank, is closed.
1. Plug the power cord into the nearest 120 volt, grounded, electrical outlet.
2. Push in the "ON" side of the ON/OFF power switch (1) to turn the compressor
on.
To Adjust The Air Regulator:
1. Turn the compressor on. When the maximum air pressure, 100 PSI, is
reached as indicated by the tank pressure gauge (3), the motor will stop.
2. Turn the pressure regulator (6) knob counterclockwise to decrease the PSI,
turn it clockwise to increase the PSI. When the output air pressure gauge (4)
shows the pressure that you want to limit the compressor to, the pressure
regulator (6) is set.
NOTE: When the maximum air pressure, 100 PSI, is reached as indicated by the
tank pressure gauge (3), the motor will stop. The compressor will automatically
restart when the air pressure drops below 85 PSI.
To Stop The Compressor:
1. Push the ON/OFF power switch (1) to its "OFF" position.
2. Press trigger on tool to relieve air pressure in hose. Disconnect hose from
air-flow valve.
3. Relieve the air tank pressure and remove moisture by opening the tank drain
valve (8). Turn the valve slowly counterclockwise until the pressure is relieved.
Then, retighten the drain valve (8). (See Figure B.)
4. Allow the air compressor to cool completely. Then store the unit in a clean,
dry, safe location out of reach of children.
WARNING! Make sure the ON/OFF power switch (1) of the air compressor is
in its "OFF" position, the unit is unplugged from its electrical outlet, and air is
drained from the tank before performing any inspection, maintenance, or
cleaning procedures or leaving it unattended.
Before each use, inspect the general condition of the air compressor. Check for
loose screws, misalignment or binding of moving parts, cracked or broken parts,
damaged electrical wiring, loose air fittings, and any other condition that may
affect the safe operation of the compressor. If abnormal noise or vibration occurs,
have the problem corrected before further use. Do not use damaged equipment.
Publicité
