Publicité
Les langues disponibles
Les langues disponibles
ADDITIONAL SAFETY INSTRUCTIONS
HANDLE THE CORD CAREFULLY. Never carry your tool by the cord or pull on the
cord to unplug it. Protect the cord from potential sources of damage: heat, oil &
solvents, sharp edges, or moving parts. Replace damaged cords immediately.
WHEN WORKING OUTDOORS, USE AN OUTDOOR-RATED EXTENSION
CORD. An extension cord rated for outdoor use must be marked "W-A" or "W".
DO NOT EXPOSE ELECTRICAL POWER TOOLS TO MOISTURE. Rain or
wet conditions can cause water to enter the tool and lead to electric shock.
STORE IDLE EQUIPMENT. Store equipment in a dry area to inhibit rust.
Equipment also should be in a high location or locked up to keep out of reach of
children.
MAINTAIN TOOLS WITH CARE. Keep tools sharp and clean for better and
safer performance. Follow instructions for lubricating and changing accessories.
Keep handles dry, clean and free from oil and grease.
AVOID UNINTENTIONAL STARTING. Be sure the switch is in the OFF position
before plugging in.
DISCONNNECT THE PLUG FROM POWER BEFORE MAKING ANY
ADJUSTMENTS. Changing attachments or accessories can be dangerous if
the tool could accidentally start.
DO NOT USE THE TOOL IF IT CANNOT BE SWITCHED ON OR OFF. Have
your tool repaired before using it.
STAY ALERT. Watch what you are doing & use common sense. Don't operate
any tool when you are tired, or under the influence of alcohol, drugs or medications
that cause drowsiness.
CHECK FOR DAMAGED PARTS. Before using this tool, any part that is
damaged should be carefully checked to determine that it will operate properly
and perform its intended function. Check for alignment of moving parts, binding
of moving parts, breakage of parts, mountings, and other conditions that may
affect its operation. Inspect screws and tighten any that are loose. Any part that
is damaged should be properly repaired or replaced by an authorized service
centre unless otherwise indicated elsewhere in the instruction manual.
Have defective switches replaced by an authorized service centre. Don't use the
tool if switch does not turn it on and off properly.
SERVICE AND REPAIRS should be made by qualified repair technicians at an
authorized repair centre. Improperly repaired tools could cause serious shock or
injury.
SYMBOLS
The following symbols are used for this tool:
SYMBOL
V
Amp
RPM
~
Hz
min
16
.
NAME
volts
amperes
revolutions per minute
AC
hertz
minutes
DESCRIPTION
voltage: electromotive force or power
electrical current
rotation speed
alternating current
current alternation frequency (cycles per second)
time measurement
Publicité
