Hendi GREEN FIRE Mode D'emploi page 10

Aansluiten van de gasfles
1 = main tap
2 = pressure regulator
3 = gas hose
4 = gas bottle
5 = rubber washer
Attach the pressure regulator to the gas bottle using
the large brass nut. Always ensure that the rubber
sealing washer is present in the nut. (NB. This rubber
washer is not required for UK-type pressure regula-
tors). Tighten the nut well. Note that the nut has a left-hand thread.
Check the connections for leaks using a soap and water solution.
Igniting the gas barbecue
• First place the side panels of the windscreen into
the applicable grooves, then attach the rear pa-
nel of the windscreen and finally place the eleva-
ted grid in the brackets on the side panels of the
windscreen.
• Put the grid and griddle on the barbecue.
EN NL
Extinguishing the gas barbecue
• Turn the knob completely to the right.
Note! After turning off the burners, wait approximately 10 minutes before reigniting the burners.
After turning off the burners, always turn off the main tap on the gas cylinder and the tap on the appliance!
Installation of windscreen and elevated grid
1. First attach the side panels and make sure they are securely fastened in the groove at the front.
10
WARNING: Some parts of the appliance can become hot.
Keep children away from the appliance.
• Turn the knob to the "big flame" position. Keep the
knob pressed and press the ignition button a few
times until the burner is burning completely. Keep
the knob pressed in for approximately a further 10
seconds. The burner will continue to burn.