Stopping The Engine; Working With The Leaf Blower - Grizzly Tools BLSB 3030 Traduction De La Notice D'utilisation Originale

1. Place the device on a stable, level
surface.
2. Switch the on/off switch (2) to „I".
3. For a cold start set the choke lever
(19) to the „START" position and
press 5 x on the fuel pump (18), until
you see fuel flowing.
For a warm start leave the choke lever
(19) in the „RUN" position.
4. Firmly hold the device with one hand
at the handle (4). With the other hand
pull the starter cable at the starter
handle (21) quickly several times in
succession until the engine starts.
Caution! Do not pull the stater cable
out too far- DANGER OF BREAK-
AGE!
5. Let the engine warm up for about 10
seconds.
6. Slide the choke lever (19) to the
„RUN" position .
If the engine has not started after
two attempts, try a warm start
without the choke in the „RUN"
position. If this is not successful,
follow the instructions in the „Trou-
bleshooting" section.

Stopping the engine

1. Release the fuel lever (3).
2. Set the on/off switch (2) to „0" to stop
the engine.

Working with the leaf blower

The leaf blower may only be
used for the following purposes:
- As a blower to pile up dry leaf
material or to blow material out
of places that are hard to access
(e.g. under cars)
- As a suction device to suck
up dry leaf material. The device
also functions as a shredder in
the suction function. The dry
leaves are shredded and their
volume is reduced, preparing
the material for later compost-
ing if desired. The shredding
intensity depends on the size of
the leaf material and its residual
moisture.
Uses other than those described
here may damage the machine
and put the operator at risk.
During work, ensure that the de-
vice is not struck against hard
objects, which can cause damage.
Do not suck up any solid bod-
ies such as stones, branches or
pieces of branch, fir cones or simi-
lar, since these can damage the
device, in particular the shredding
mechanism. Repairs of this type
are not covered by the guaran-
tee.
You should always work with the
lowest possible engine rpms, since
with reduced engine power the
noise level and fuel consumption
will be reduced as well.
Blowing operating mode:
For safety reasons, make sure the
intake cover is properly closed.
• Put on the neck strap (28) and ad-
just the strap in such a way that the
blower pipe is at a distance of 5 - 10
cm from the ground.
• Hold the device on your right hand
side and do not touch the exhaust.
Risk of burn injury.
GB
97