Spark Plug Maintenance; Replacing The Collection Bag; Service Intervals - Grizzly Tools BLSB 3030 Traduction De La Notice D'utilisation Originale

Aspirateur et souffleur de feuilles thermique
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 39
GB
1. Switch off the equipment.
2. Press the locking devices (36) at the
air filter cover (20) and remove the air
filter cover.
3. Remove the air filter (37) from the air
filter cover (20).
4. Clean the air filter (13) with soap and
water.
Never use petrol!
5. Allow the filter to dry in the air.
6. Reinsert the filter in reverse order.
Clean the air filter regularly (see
"Service intervals"). Replace the
air filter if it is worn, damaged or
dirty. Replace the air filter if it is
worn, damaged or heavily soiled.

Spark plug maintenance

Worn spark plugs or a spark gap
that is too large will result in a re-
duction of motor power.
1. Turn off the device.
2. Pull the spark plug connectors (11)
from the spark plugs (38).
3. Unscrew the spark plug (38) counter
clockwise with a spark plug wrench
(Service key 32).
Machine part
Spark plug
Spark plug
Spark plug
Airfilter
Airfilter
Airfilter
* in a high dust environment, clean the air filter after every 4 operating hours
100
Before ev-
Action
ery use
Check
Clean
Replace
Check
Clean *
Replace
4. Check the spark plug gap with the
help of a feeler gauge (available from
specialised dealers). The electrode air
gap must be 0.6-0.7 mm.
5. Reset the gap if necessary, by careful-
ly bending the ground/side electrode
of the spark plug.
6. Clean the spark plug with a wire brush.
7. Reinsert the cleaned and reset spark
plug or replace any damaged spark
plugs with a new one (e.g. "Torch
L8RTC or Champion RCJ6Y" spark
plug).
8. Replace the spark plug connector (11).

Replacing the collection bag

Replace a defective collection bag. Em-
ploy only original collection bags (see
chapters "Spare Parts"), otherwise the
guarantee claim is invalid.

Service intervals

Carefully perform the maintenance tasks
listed in the following table on a regular
basis. Regular servicing of your unit will
extend the life of your equipment. Addi-
tionally, you will achieve optimum cutting
performance and prevent accidents.
After 10 hours
of operation
if required
if required
After 25 hours
of operation

Publicité

Table des Matières
loading

Table des Matières