Installing/Removing Blower Pipe And Blower Attachment; Installing/Removing Two-Piece Suction Pipe; Installing/Removing The Collection Bag; Attaching The Neck Strap - Grizzly Tools BLSB 3030 Traduction De La Notice D'utilisation Originale

Installing/removing
blower pipe and blower
attachment
1. Screw on the desired blower attach-
ment (26/27) clockwise onto the blow-
er pipe (25), until the two parts snap
firmly into place.
2. Loosen the fixing bolt (12) at the
mounting collar (13) of the engine
housing (5).
3. Slide the blower pipe (25) into the
discharge chute (10). The lug on the
blower pipe fits into the recess on the
engine housing (position).
4. Turn the blower pipe (25) clockwise
until the two marks show in a
stacked (position).
5. Retighten the fixing bolt (12).
6. Remove the blower pipe and blower
attachment in reverse order.
Installing/removing two-
piece suction pipe
1. Fit the two suction pipes (23a+b) to-
gether.
2. Attach the two pipe pieces with the
supplied bolt and nut (33).
For security reason the two pipe
pieces cannot be taken apart later.
3. Loosen the fixing bolt (6) of the intake
cover (7) and open the intake cover.
4. To install the upper suction pipe (23a)
in the engine housing (5), position the
plastic hook (22) at the spring hinge
(34) of the intake cover (7).
5. Slide the two-piece suction pipe (23)
into the intake opening (8) and screw
fasten it with the enclosed fixing
screws (35).
As a safety precaution you can
only turn on the device if both pipe
parts have been correctly mounted
on the engine housing.
6. Remove the suction pipe (23) in re-
verse order.
Installing/removing the
collection bag
In suction mode the device can
only be operated with the collec-
tion bag installed.
1. Attach the collection bag (30) to the
intake pipe (29) using the Velcro strip.
2. If necessary, remove the blower pipe
(25) (see „Installing/removing blower
pipe and blower attachment").
3. Mount the intake pipe (29) of the col-
lection bag (30) at the discharge chute
(10) on the engine housing (5) as
described under „Installing/removing
blower pipe and blower attachment".

Attaching the neck strap

Always wear a neck strap when
operating the device. Always turn
off the device, before removing
the neck strap. Accident hazard.
Attach the snap hook of the neck strap
(28) to the fixing lugs (1a+b) on the en-
gine housing (5).

Fill with Fuel

Always ensure good ventilation
when handling fuel.
Do not smoke when refuelling and
keep away from any heat sources.
Never refuel with the motor run-
ning or hot.
GB
95