Publicité
Les langues disponibles
Les langues disponibles
5
Tools Needed:
– Phillips Head screw driver.
– 7 mm open end wrench.
1. Align holes in heater leg frame with lower inner
bracket.
2. Attach lower outer bracket to lower inner
bracket using screws.
3. Align lower inner bracket with side support.
4. Attach side supports to heater using tilt
adjustment knob.
5. Slide side supports into upper brackets, align
holes and insert screws to tighten.
6. Slide upper handle brackets onto front handle,
align holes and insert screws to tighten.
7. Slide rear handle into upper handle brackets,
align holes and insert screws to tighten.
© 2019 Pinnacle Climate Technologies, Inc.
NEVER LEAVE HEATER UNATTENDED WHILE
®
ASSEMBLY INSTRUCTIONS
1 / 2
CONNECTED TO A POWER SOURCE
6 / 7
4
3
4
Turbo Electric Fan Heater User's Manual
Publicité
