Rj-45 Port; Connecting Alarms; Connecting The Power - Eneo ISM-53M2812W0A Guide D'installation Rapide

RJ-45 port

Connect a standard RJ-45 cable to the network port of the network camera. Generally a
cross-over cable is used for directly connection to PC, while a direct cable is used for con-
nection to a hub. You can also use a router featuring PoE (Power over Ethernet) to supply
power to the camera.

Connecting Alarms

AI (Alarm In): You can use external devices to signal the network camera to react on
events. Mechanical or electrical switches can be wired to the AI (Alarm In) and G (Ground)
connectors.
G (Ground): Connect the ground side of the alarm input and/or alarm output to the G
(Ground) connector.
AO (Alarm Out): The network camera can activate external devices such as buzzers or
lights. Connect the device to the AO (Alarm Out) and G (Ground) connectors.

Connecting the Power

Connect the power of 12 VDC for the network camera. Connect the positive (+) pole to
the '+' position and the negative (-) pole to the '-' position for the DC power.
• Be careful not to reverse the polarity when connecting the power cable.
• A router featuring PoE (Power over Ethernet) can also be used to supply power to
the camera.
• For the power specifications, refer to the Appendix, Product Specification.
EN
7