Inoksan BYM052 Mode D'emploi page 14

3-The device does not take
water.
4-The device continuously
takes water.
5-There is rusting on the
device surface
BYM052 Malfunction Codes:
In case of malfunction, your device turns itself OFF and the related malfunction codes are displayed on the
screen (as can be seen above).
DESCRIPTION
NO WATER
ER 01
ER 02
Boiler NTC Malfunction
ER 03
Tank NTC Malfunction
Boiler HEATER
ER 04
Tank HEATER
ER 05
Thermal Relay or
ER 06
Power-box Malfunction

Malfunction codes are removed by themselves when the Sensor and Thermal malfunctions are solved.

To remove other codes, push the ON/OFF button.
1. ERKLÄRUNG
1. Die Anweisungen dieser Anleitung beinhalten
wichtige İnformationen über die zuverlässige
Montage, Gebrauch, Reinigung und Pflege
des Gerätes. Bewahren sie deshalb diese
Gebrauchsanweisung an einem durch den
Verbraucher
erreichbaren Ort auf.
2. Die Montage des Gerätes sollte durch einen,
vom Hersteller der Maschiene beauftragten
-Machine may
overloaded.
-Water inlet valve may be closed.
-Cover may not
completely.
-Solenoid valve may be broken.
-Pressure stat may be defective.
-Pressure stat hose may have taken
in air.
-Improper chemical materials
may have been used.
Tank pressurestat does not detect the water level for 10 min. if its
Malfunction (if no signal is received for 10 min. at input no.9 during machine
When temperature increase of at least 5 ºC(41°F) is not ensured for
Malfunction
contactor, has been working for at least 10 min. continuously.)
When temperature increase of at least 5 ºC(41°F) is not ensured for
Malfunction
contactor, has been working for at least 15 min. continuously.)
(When there is no energy at input no.16 of the electronic card)
und Techniker
have been
-Check/Open
be closed -Check/Close
-Notify the authorized service.
-Notify the authorized service.
-Empty the water inside the tank and restart the
device.
-Clean the device according to the instructions for use
DETECTION
position is not changed.
water intake)
Sensor short or open circuited
Sensor short or open circuited
10 min. in the boiler.
(To be controlled when the boiler output no.11, i.e. the K2
15 min. in the tank.
(To be controlled when the boiler output no.10, i.e. the K3
When there is no energy at washer pump thermal relay output
und
Anweisungen
durchgeführt werden.
3. Die Wasser und Strom Verbindungen des
Gerätes sollten den Werten der Tabelle der
"Technischen
leicht gemacht werden.
4. Das
14
erfahrenen Fachexperten,
der Firma
Eigenschaften"
regelrechte Funktionieren
Langlebigkeit ihrer
hängt zweifellos
DE
den
anpassend
anpassend
und
Spülmaschiene
vom richtigen