Inoksan BYM052 Mode D'emploi page 11

 5
Less dirty button
will flash red when selected
 6
Dirty button
will flash red when selected
 7
Very dirty button
will flash red when selected
 8
Rinse led
Will flash red during rinsing
 9
Boiler temperature
Red double digit
 10
Drain button
Will flash red during manual or automatic
draining
 ON
 WATER INTAKE
Y1+M2 valve. Boiler and Tank is full when P1-
Pressure stat is seen
(6lt.)
 HEATING
then the Tank is heated
 READY
when Boiler and Tank reach the correct
temperature
Heaters are active during the waiting process
ON button
START <–> PAUSE (2 sn STOP)
Tank Temperature Indicator
Ready led
Lightly dirty Button
Dirty Button
Very Dirty Button
Fill water with
First the Boiler is heated,
START will be permitted
(Prm. Option : Permit START when not
ready)
 START
 WASHING
 FILTERING
 RINSING
(Rinsing pump) active + PD (Polisher) output
active
 FILTERING
 FINISH
the

MANUAL DISCHARGE:
When the device is on or in standby mode, plastic
plug in the tank is removed and DISCHARGE
button is pressed during 2 seconds. Discharge
button blinks, which is a sign that the process has
started. When the process is over, the device shuts
off automatically (it goes into OFF mode.)
11
M1 Washing engine active
(Heating active)
~5 sec wait
(Heating active)
Y1(Water intake)
( Heaters passive)
~5 sec wait
(Heating active)
START led flash
(Heating active for the next wash)
(OFF when pressed for 2 sec.)
Red light sill appear in
stand-by condition, and green
light will appear when it is on
Green will be on when the
machine is working, and it will
be blinking if paused.
The digit red temperature
indicator. It blinks at the right
bottom when heating is on.
Red will be on when the Boiler
and Tank temperatures are
ready
Red light will appear when
chosen
Red light will appear when
chosen
Red light will appear when
chosen
and M2