Possible Faults - Crivit 306200 Notice D'utilisation

Possible faults

Possible faults, their causes and the resolution are described in the following .
Fault
Remote control (2) is
not responding .
Quadrocopter (1) is
not responding .
Quadrocopter (1) is
uncontrollable .
Quadrocopter (1) is
not flying upwards .
Rotor guard (1c) is
not secure .
The quadrocopter
(1) lights (1h) blink
alternately .
Possible cause
Remote control (2) is
switched off .
Batteries (5) are inserted
incorrectly .
Batteries (5) are empty .
The batteries (5) in the
remote control (2) have
been inserted incorrectly or
are empty .
Storage battery (9) in the
quadrocopter (1) is empty .
Control lamps (1h) are not
flashing or not on .
Quadrocopter (1) out of
range .
Wind or draught is too
strong .
Quadrocopter (1) needs
calibrating .
Not enough throttle .
Storage battery (9) is
empty .
Collision, crash
The quadrocopter (1) is not
connected to the remote
control (2)
The rechargeable battery
(9) is almost flat .
Resolution
Switch remote control (2) on .
Insert batteries (5) correctly .
Change batteries (5) .
Check the batteries (5) and change them if necessary .
Charge the storage battery (9) .
Connect the remote control plug connector (9a) to the
quadrocopter plug connection .
Make sure that the distance between the remote control
(2) and the quadrocopter (1) is not more than 50m .
The quadrocopter (1) is only suitable for almost wind-
still conditions up to wind force 3 .
Switch the quadrocopter (1) on and place it on a level,
smooth surface . Switch the remote control (2) on and
simultaneously push the throttle backwards and to the
left and the joystick (2h) backwards and to the right .
The control lamps (1h) on the quadrocopter (1) will
flash for approx . 3seconds . As soon as the control
lamps (1h) are lit constantly the calibration is complete
and the quadrocopter (1) is ready to fly .
PLEASE NOTE: Repeat the calibration if the
quadrocopter (1) continues to fly uncontrollably
in one direction .
Push the throttle (2h) all the way forwards .
Charge the storage battery (9) .
If a rotor guard (1c) becomes loose then please tighten
the screws again and check the functioning and correct
position of the rotor guard (1c) .
Slide the throttle (2h) on the remote control (2) all the
way forward, and then all the way back .
This process establishes contact between the quadro-
copter (1) and the remote control (2) .
Switch off the quadrocopter (1) and remove the
rechargeable battery, so it can be charged .
GB/IE/NI 21