Foreseeable Misuse; Inserting The Batteries Into The Remote Control - Crivit 306200 Notice D'utilisation

• If the rechargeable battery burns during the
charging process, extinguish this type of re-
chargeable battery with plenty of water .
• The USB charging cable may only be used in
dry, closed indoor areas . The USB charging
cable and battery may not get damp
or wet .
• Never short-circuit the battery terminals . There is
a risk of fire or explosion .
• Never carry rechargeable batteries in trouser
pockets or carrier bags . Watch out for sharp
or angular objects which could damage your
battery .
• If the rechargeable battery has been subjected
to a strong surge, store it in a very secure place
(e .g . in a metal box) for the next 30 minutes . Pay
attention to whether the rechargeable battery
swells and/or overheats .
• Never try to manipulate, modify or repair the
rechargeable battery .
• After the flight, disconnect the battery from the
electronics of the Quadrocopter . Do not leave
the battery connected to the electronics if you
are not using the device (e .g . during transport or
storage) . Otherwise, the battery could be heav-
ily discharged . As a result, it will be destroyed
and unusable! There is also the risk of malfunc-
tion due to interference impulses . The rotors
could start unintentionally and cause damage or
injury .
• Never damage the outer shell of the battery .
Do not cut the foil sheath . Do not pierce the
rechargeable battery with sharp objects . There is
a risk of fire and explosion!
• Dispose of used batteries after the end of their
life span properly at local collection points or
retail outlets .

Foreseeable misuse

Take care not to misuse the item in the following
ways:
• Do not operate the quadrocopter in unsuitable
weather or environmental conditions (e .g . in rain,
snow, fog or at night) .
• Do not operate the quadrocopter in too small
a space (under 6 x 4m), or if there are objects,
people or animals within a radius of 5m .
14 GB/IE/NI
• Never fly over flight exclusion zones, prohibited
areas or official installations, and always comply
with the minimum distances from such areas (see
also "Safety information") .
• Do not invade the personal space of others (e .g .
with the camera function) .
• Do not give the item to anyone under the age of
14 years .
• Attaching loads or making modifications in any
way is strictly prohibited .
• Do not operate the quadrocopter if there are
loose or defective parts (e .g . after a
collision or crash) .
Inserting the batteries into the
remote control (Fig. D)
CAUTION: Observe the following
instructions to avoid mechanical
and electrical damage.
Insert the enclosed batteries (5) into the battery
compartment (2r) of the remote control (2) .
Inserting the batteries
1 . Using the Phillips screwdriver (8), loosen the
screw (2q) of the battery compartment lid on the
back of the remote control (2) and remove the
lid (2q) .
2 . Carefully insert 2 x 1 .5V LR6-type batteries (5)
into the battery compartment (2r) . The batteries
must fit into the battery compartment complete-
ly (2r) .
CAUTION: Check the positive/negative
poles of the batteries (5) and ensure that
they are inserted correctly, as marked
on the bottom of the battery compart-
ment (2r) .
3 . Secure the battery compartment lid (2q) onto
the back side once again .
Replacing the batteries
CAUTION: Observe the following
instructions to avoid mechanical
and electrical damage.
Should the batteries (5) no longer function, replace
them as described in the instructions above .
Remove the batteries (5) that are in the device
before inserting new ones (5) .