Ac Adapter - Brother P-touch PT-2100 Guide De L'utilisateur

GETTING STARTED

AC Adapter

Connect the AC adapter directly to the P-touch labeler.
Insert the plug on the AC adapter cord into the connector marked DC IN 9-9.5V
1
on the P-touch labeler.
Insert the AC adapter plug into a standard electrical outlet.
2
Remove the batteries if you do not intend to use the P-touch for an extended period of time.
• Turn the P-touch labeler off before disconnecting the AC adapter.
• Do not pull or bend the AC adapter cord.
To safe guard and backup the labeler's memory, when the AC adapter is unplugged it is
recommended to have AA-size alkaline batteries (LR6) installed into the machine.
• Use only the adapter (AD-24), which is designed exclusively for your P-touch.
Failure to observe this may result in an accident or damage. Brother shall not
assume any responsibility for any accident or damage resulting from not using the
specified AC adapter.
• Do not connect the AC adapter to a non-standard electrical outlet. Failure to
observe this may result in an accident or damage. Brother shall not assume any
responsibility for any accident or damage resulting from not using a standard
electrical outlet.
• Disconnect the AC adapter from the P-touch and electrical outlet when you do not
intend to use the P-touch for an extended period.
• When power is disconnected for more than two minutes, all text and format settings
will be cleared. Any text files stored in the memory will also be cleared.
18 Power Supply
WARNING
CAUTION