EDM Product 08761 Manuel D'instructions page 37

Chain saw
Features
1. Release the handwheel and take off the chain cover
2. Place the saw chain around the guide bar,starting at the
top section of the bar.Insert the saw chain in the
circumferential groove.When inserting the chain, observe
the correct running direction of the chain
3. Place the guide bar with the elongated hole on the stud
bolt and guide bolt on the chainsaw. Run the saw chain
around the chain wheel.
EN INSTRUCTION MANUAL
4. (1)Put the the chain cover's sign and the adjust knob's
sign in the Vertical alignment.(Fig.1)
(2) Fit the chain cover. Tighten the handwheel clockwise for
fastening the rail and chain cover.(Fig.2)
(3)The adjust knob adjusting the chain tension.(Fig. 3)
The saw chain must not sag, although it should be possible
to pull it 1-2 millimetres away from the guide bar in the
centre of the guide bar.
REF. 08761
Fig.1
Fig.2
Fig.3