Maintenance; Storage; Troubleshooting / Repairs - Senco SRT25 Mode D'emploi

3. Push the reel stopper to release the reel stay and
open it at the same time, and remove the wire coil.
Reel stopper
4. Load new wire coil (refer to the instructions for
loading wire coil on page 9)
5. Battery saving function.
The machine will automatically shut down after 10
min stand-by without being used.

Maintenance

1. Clean and check the rebar tying tool on a regular
basis�
2. Clean the feeding gear and surrounding areas on a
regular basis, to avoid dust and metal residue getting
into the machine and causing problems� This can be
done with an air blow gun�
3. Clean the brake gear with compressed air and
apply non-acid oil.

Storage

The rebar tying tool must not be stored in cold
conditions. It should be kept at approx. 20°C. When
the machine is not in use, it should be stored under
warm and dry conditions. Keep the machine out of
the reach of children.
Reel stay

Troubleshooting / repairs

The rebar tying tool will eventually need mainte-
nance service and replacement of worn parts due to
normal wear and tear� Troubleshooting and/or repairs
are only to be carried out by authorised dealers or
specialists�
The rebar tying tool warns about malfunctions using
beep sounds. Follow the matrix on page 12 to find out
what is wrong�
WARNING! If one of the problems listed on page 12
occurs, set the main switch to OFF position, before
trying to solve the issue�
When the main switch is set to ON - do not place your
fingers near the curl guide or other moving parts of
the machine. If the problem still occurs, set the main
switch to OFF and contact the dealer�
EN
11