How To Replace The Wire Coil; Correct Use - Senco SRT25 Mode D'emploi

10. Adjusting the wraps
EN
By default the machine is set for 3 wraps. Changing
the setting to 2 wraps: Turn off the machine on the
main switch� Press and hold the trigger while turning
on the main switch. The machine is now set for 2
wraps per tie. If the machine is turned off, it will auto-
matically be set for 3 wraps again.
11. The torque setting unit adjusts the tension of the
ties. 1. digit displays the wrap setting (3 is default)
and 2� digit displays the torque setting�
The torque can be adjusted higher
means of the push buttons.
We recommend:
• 2 wraps = position 1 - 5
• 3 wraps = position 6 - 9
12. Perform a test tie, to check if the torque is set
correctly�

Correct use

1. Place the arm A unit in a 45° angle over the re-bar
cross surface and push the mouth towards the re-bar�
2. Place Arm A perpendicularly on top of the re-bar
cross surface and with the mouth centred over the
cross�
10
or lower
45°
!
WARNING! Do not move the rebar tying tool
!
while it is tying�
3. The ties should be made in alternating directions�
by 4. Cross-tying.
Bend down the knot of the first tie, before you make
the second tie�

How to replace the wire coil.

WARNING! Set the main switch to OFF po-
!
sition, activate the trigger lock and remove
the battery�
1. Push the release lever until it is caught by the
release stopper�
Release lever
Release stopper
2. Remove the wire coil�
Pipe
Wire