Controls overview(fig. b)
Power
Turn on or turn off
G
button
the humidifier.
Set the timer for
H
Timer button
the humidifier
(1H, 4H, and 8H).
Adjust the fan
speed
Fan speed
I
(AUTO,
button
and
Set the relative
Humidity
J
humidity level (40,
button
50 or 60).
The indicator
blinks when there
Water level
K
is not enough
indication
water in the
reservoir.
(low)
,
(normal),
(high)
.
3 Getting started
Prepare the humidifier
1
Place the humidifier on a flat, stable
surface, about 4 inches (10cm) away
from an inside wall. Make sure the
surface is not sensitive to moisture.
2
Hold by both sides of the upper unit
to lift it up (fig. c).
3
Remove the packaging material of
the new humidification filter (fig. d).
4
Assemble the new humidification
filter around the filter support
(fig. e).
5
Put the filter and the filter support
back into the water tank (fig. f).
6
Fill the reservoir with approximately
67 fl. oz/2000ml cold tap water
until water reaches the maximum
water level indication (fig. g).
7
Place the upper unit back onto the
reservoir (fig. h).
Note
•
DO NOT overfill the reservoir.
•
Always empty the reservoir before
refilling with clean, cold tap water. Rinse
the reservoir, wipe clean and dry with a
clean cloth or paper towel. For complete
cleaning instructions, see section 'Clean
your humidifier'.
EN
7