Removing Scale; Disinfecting The Reservoir; Cleaning The Filter - Philips HU4805 Mode D'emploi

Removing scale

1
Switch off the humidifier and unplug
from the electrical outlet.
2
Remove the upper unit by holding it
at both sides (fig. c).
3
Remove filter and filter support from
the reservoir (fig. p).
4
Empty reservoir.
5
Fill reservoir with 8oz./236.5ml
undiluted white vinegar. Let solution
sit in reservoir for 20 minutes
(fig. s).
6
Clean all interior surfaces with
a soft brush. Dampen soft cloth
with undiluted white vinegar and
wipe out reservoir to remove scale
(fig. t).
7
Rinse thoroughly with clean, warm
water to remove scale and cleaning
solution before disinfecting the
reservoir (fig. u).

Disinfecting the reservoir

1
Follow the instructions for removing
scale.
2
Place reservoir in a sink. Fill reservoir
with a solution of 1 tsp/5g chlorine
bleach in 1 gal/3.78liters water. Let
solution stay 20 minutes, swishing
every few minutes. Wet all surfaces
(fig. v).
3
Empty reservoir and rinse with water
until bleach smell is gone (fig. w).
4
Dry the inside and outside of the
reservoir with a soft, clean cloth or
paper towel (fig. x).
5
Put the filter and filter support back
into the reservoir (fig. f).
6
Place the upper unit back onto the
reservoir (fig. h).
12 EN

Cleaning the filter

1
Take out the filter and the filter
support from the reservoir (fig. p).
2
Remove the filter from the filter
support (fig. q).
3
Soak the filter in tap water for one
hour (fig. r).
4
Rinse the filter under a slowly
running tap water. (fig. y).
5
Let excess water drip off the filter.
6
Assemble the filter around the filter
support (fig. e).
7
Put the filter and the filter support
back into the reservoir (fig. f).
8
Put the upper unit back onto the
reservoir (fig. h).
Note
•
Do not squeeze or wring the filter. This
might damage the filter and impact the
humidifier's performance.
•
Do not dry the filter under direct
sunlight.