Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
Problem
Possible cause
The machine does
The battery is not
not start.
charged.
The switch is de-
fective.
Battery is too cold. Remove battery
Blue LED light is
Flashing - Battery
is in Low Voltage
Protection.
Blue LED light is
always on - Bat-
tery Temperature
is Low.
Battery may re-
quire service or re-
placement.
English
Solution
Problem
Charge the battery
The engine is on,
by following the
but the impeller
procedures in the
does not turn.
battery and charg-
A thin layer of
er manual.
snow stays behind.
Have the switch
replaced by an au-
* If you cannot find the solution to these problems, call
thorized service
1-855-345-3934 .
center.
11
from snow throw-
er. Place battery on
Voltage
charger and allow
No load speed
to charge for 10
minutes or until
Clearing width
the changing light
Clearing depth
turns green. Re-
move from charger
Impeller size
and install in snow
Weight (without battery
thrower for use.
pack)
Bring the Battery
Battery
and Charger in to a
warm area. Place
the Battery in the
Charger
charger and allow
for the battery to
reach room tem-
perature or when
12
the light on the
charger is flashing
Green. Once
charger is flashing
green, take the bat-
tery and place it in
the unit to begin
work.
Bring the Battery
and Charger in to a
Greenworks hereby warranties this product, to the original
warm area. Place
purchaser with proof of purchase, for a period of four (4)
the Battery in the
years against defects in materials, parts or workmanship.
charger and allow
Greenworks, at its own discretion will repair or replace any
for the battery to
and all parts found to be defective, through normal use, free
reach room tem-
of charge to the customer. This warranty is valid only for
perature or when
units which have been used for personal use that have not
the light on the
been hired or rented for industrial/commercial use, and that
charger is flashing
have been maintained in accordance with the instructions in
Green. Once
the owners' manual supplied with the product from new.
charger is flashing
green, take the bat-
tery and place it in
the unit to begin
work.
Call toll free help-
line, at
1-855-345-3934 or
replace battery.
13
Possible cause
The belt is dam-
aged.
The scraper is
damaged.
TECHNICAL DATA
60 V
1800 RPM
20 in. (50.8 cm)
10 in. (25.4 cm)
16 in. (40.6 cm)
31.5 lbs (14.3kg)
LB604 and other BAC
series
CAC801 and other CAC
series
LIMITED WARRANTY
GARANTIE OUTIL &
BATTERIE • GARANTÍA PARA
HERRAMIENTAS Y BATERÍAS
EN
Solution
Replace the belt.
Replace the scra-
per.
Publicité
Table des Matières
