Troubleshooting; Technical Data; Limited Warranty - GreenWorks Pro SNB403 Manuel D'opérateur

10

TROUBLESHOOTING

Problem Possible
cause
The handle is The bolts are
not in posi- not engaged
tion. correctly.
The machine The battery is
does not start. not charged.
The switch is
defective.
Battery is too
cold.
Blue LED
light is Flash-
ing - Battery
is in Low
Voltage Pro-
tection.
Blue LED
light is al-
ways on -
Battery Tem-
perature is
Low.
Battery may
require serv-
ice or re-
placement.
The engine is The belt is
on, but the im- damaged.
peller does not
turn.
English
Solution
Adjust the height of the
handle and make sure that
the knobs and bolts are
aligned correctly.
Charge the battery by fol-
lowing the procedures in
the battery and charger
manual.
Have the switch replaced by
an authorized service cen-
ter.
Remove battery from snow
thrower. Place battery on
charger and allow to charge
for 10 minutes or until the
changing light turns green.
Remove from charger and
install in snow thrower for
use.
Bring the Battery and
Charger in to a warm area.
Place the Battery in the
charger and allow for the
battery to reach room tem-
perature or when the light
on the charger is flashing
Green. Once charger is
flashing green, take the bat-
tery and place it in the unit
to begin work.
Bring the Battery and
Charger in to a warm area.
Place the Battery in the
charger and allow for the
battery to reach room tem-
perature or when the light
on the charger is flashing
Green. Once charger is
flashing green, take the bat-
tery and place it in the unit
to begin work.
Call toll free helpline, at
1-855-345-3934 or replace
battery.
Replace the belt.
Problem Possible
cause
A thin layer of The scraper is
snow stays be- damaged.
hind.
* If you cannot find the solution to these problems, call
1-855-345-3934 .
11

TECHNICAL DATA

Voltage
No load speed
Clearing width
Clearing depth
Impeller size
Weight (without battery
pack)
Battery
Charger
Double-insulated construc-
tion
12

LIMITED WARRANTY

BATTERIE • GARANTÍA PARA
HERRAMIENTAS Y BATERÍAS
Greenworks hereby warranties this product, to the original
purchaser with proof of purchase, for a period of four (4)
years against defects in materials, parts or workmanship.
Greenworks, at its own discretion will repair or replace any
and all parts found to be defective, through normal use, free
of charge to the customer. This warranty is valid only for
units which have been used for personal use that have not
been hired or rented for industrial/commercial use, and that
have been maintained in accordance with the instructions in
the owners' manual supplied with the product from new.
ITEMS NOT COVERED BY WARRANTY:
1. Any part that has become inoperative due to misuse,
commercial use, abuse, neglect, accident, improper
maintenance, or alteration; or
13
Solution
Replace the scraper.
80 V
1800 RPM
22 in (55.9 cm)
13 in (33.0 cm)
18 in (45.7 cm)
25.8 kg (56.9 lbs)
BAB727 and other BAB ser-
ies
CAB812 and other CAB812
series
GARANTIE OUTIL &
EN