Camera Programming - Stealth Cam V30NGKX Manuel D'instructions

This V30NGKX features 3 Modes (OFF / TEST/ ON) and
6 distinct Qset options.
OFF – This position completely powers down the unit.
ON – This position turns the unit ON allowing it to capture
images/videos based on the operational mode the unit is
set. The unit will automatically enter Date & Time menus
on initial startup.
• While ON the unit will remember the last set operational mode.
• Pressing the UP and DOWN button cycles the available modes
respectively. (Qset1 / Qset2 / Qset3 / Qset4 / Qset5 / Qset6 / Custom)
TEST – This is the final switch setting, and is used to determine the camera's PIR sensor coverage
area. When moved to this setting the display will display TEST. Simply walk back and forth in
front of the camera, the light will illuminate green when you have passed into the coverage area.
On Screen Display - While the Camera is ON the Alphanumeric Screen will display Mode, Battery
Life, and Capture Type.
Qset Modes
Qset1 – 3 Photo Burst, Low Resolution, 30 Second Delay between triggers.
Qset2 – 1 Photo Burst, High Resolution, 30 Second Delay between triggers.
Qset3 – 10 Second Video, 720P Resolution, 30 Second Delay between triggers.
Qset4 – 3 Photo Burst, Medium Resolution, 5 Second Delay between triggers.
Qset5 – 2 Photo Burst, Medium Resolution, 90 Second Delay between triggers.
Qset6 – 15 Second Video, 720P Resolution, 5 Second Delay between triggers.
www.stealthcam.com
877-­‐269-­‐8490
CAMERA PROGRAMMING
PHOTO / VIDEO / TL – (Delay) Camera ready after 30 secs
7
Page