Palmer RIVER Serie Manuel D'utilisateur page 13

USER MANUAL
wipper
CONNECTIONS AND OPERATING ELEMENTS
1. INPUT A
Audio input with 6.3 mm jack socket.
A. Connect an instrument using a
shielded instrument cable.
B. Connect the speaker output of a
guitar amplifier using a speaker cable
(tip: Press PAD switch no. 5).
WARNING:
WARNING:
input and output must be disconnected (switch no. 6 in the non-pressed LIFT position).
WARNING:
ohms!
ATTENTION:
In order to avoid damage to the amplifier, a suitable guitar speaker or a suitable load resistor
must be connected to the THRU jack socket using a speaker cable before switching on the
amplifier, and switch no. 3 must be in the unpressed LINK OUT position!
2. THRU/INPUT B
THRU: The input signal (INPUT A no. 1) is output unchanged via the 6.3 mm jack socket (switch no. 3 in non-pressed
position).
INPUT B: In addition to INPUT A, the 6.3 mm jack socket can be used as a second line input (e.g. keyboard L + R);
the signals from INPUT A and INPUT B are mono summed and output at the line output OUTPUT (no. 4) (switch no. 3
in pressed position).
3. SWITCH THRU/INPUT B
Switch not pressed (THRU): The input signal (INPUT no. 1) is output unchanged via the 6.3 mm THRU/INPUT B jack
socket.
Switch pressed (INPUT B): In addition to INPUT A (no. 1), the 6.3 mm THRU/INPUT B jack socket can be used as a
second line input.
EN
Amplifiers must not be operated in bridge mode on the DI box.
If an amplifier is operated on the DI box, the ground connection between
The amplifier output of a connected amplifier must not exceed 120 W at 8
When using a tube amplifier: There is no load resistance in the DI box circuit!
DI box
passive
13