Technical Data - D+H KA 34 Notice Originale

Technical data

Type
Power supply
Nominal force
Nominal locking force
Lifetime
Duty cycle
Housing
Ingress protection
Temperature range
Fire stability
Nominal stroke length * ** see type plate
Additional functions **
* adjustable with PLP 1
Running speed and forces
Normal operation =
SHEV- fast running =
KA 34: 300** N, 11,8 mm/s =
"-HS" KA 34 12,2 mm/s
(with tensile force (1/2 nominal load) 16,1 mm/s)
KA 54: 500** N, 11,8 mm/s =
"-HS" KA 54 13,3 mm/s
(with tensile force (1/2 nominal load) 17,2 mm/s)
Clamping protection
In "CLOSE" direction the drive has an active
clamping protection for the main closing edge. With
an overload in the closing range 3 and 2 the drive
runs "OPEN" for 10 seconds, then drive "CLOSE"
again. If after three attempts a closing is not possible,
the drive remains in this position.
In addition, the drive has a passive clamping
protection. The closing speed in closure Range 2
and 1 is reduced to 5 mm/s.
Higher forces can occur on besides
closing edges. Danger of violent
pressure in handaccessible area.
6/12
KA 34 / KA 54
KA 34
24 V DC / ±15% / 1,0 A
300 N
1000 N
>10 000 double strokes
30 % (with cycle time 10 minutes)
anodized aluminium
IP 32
(with covering stoppers delivered with bracket sets)
-5 ... +75°C
30 min / 300°C
/
clamping protection activated (3 stroke repeatings), locking relief activated
** programmable with PLP 1 and PDA Servicetool
=
=
KA 54
24 V DC / ±15% / 1,4 A
500 N
English
** + 20 % switch-off reserve
(temporary)
99.823.88 2.0/11/09