Publicité
Les langues disponibles
Les langues disponibles
NoticeEoh-4Trads-FRENESIT-MAJ092021.qxp_Mise en page 1 29/09/2021 16:52 Page 21
10 - Press the required button: Small coffee (
selected button will remain on and the other button will go out. The coffee is on its way.
The coffee cycle stops automatically at the end of the cycle or can be interrupted
manually by pressing the selected button again.
11 - After the coffee pod has brewed, raise the handle as far as possible ( ) while pulling towards
you, the used pod will then fall into the used pod basket (
make another coffee.
P R O G R A M M I N G
The 2 coffee options (small or large) are pre-programmed by default (4 cl for a small
coffee and 12 cl for a large coffee). You can change these volumes as follows:
1 - Start the machine (see instructions in the above section). The white lights on the coffee
buttons (
3
) and (
make coffee). Check that the water tank (
2 - Press and hold the coffee button for the volume you wish to change for at least 5
seconds. The white light on the button will then flash rapidly, and the central indicator
2
(
) will light up white. The machine is now in programming mode.
3 - Raise the handle (
4 - Lower the handle (
selected previously, which is now flashing), the central light will go out and the machine
will start to pour the coffee.
5 - Once the required volume of coffee has been poured, press the same button again
to stop serving and save the selected volume.
6 - The white light on the programmed button will then stay ON (together with the light
on the other coffee button), the programming has been saved for the button. The machine
is ready to make coffee.
Note: the factory settings for coffee options can be recovered as follows:
1 - Start the machine (see instructions in the above section). The white light on the coffee
buttons (
3
) and (
make coffee).
2 - Press and hold the coffee button for the volume you wish to change for at least 5
seconds. The white light on the button will then flash rapidly, and the central indicator
2
( ) will light up white. The machine is now in programming mode.
3 - Press and release the other coffee button: the button light will stop flashing, factory
settings are re-established, the two coffee button lights (
the machine is ready to serve coffee.
4
) must stay ON (the machine is at the right temperature, ready to
) and insert a pod.
1
) and press the coffee option to be programmed (the button
1
4
) must stay ON (the machine is at the right temperature, ready to
3
) or Large coffee (
). The machine is then ready to
7
6
) contains enough water to enter settings.
3
) and (
). The light on the
4
1
4
) will come ON, and
20
Publicité
