Publicité
Les langues disponibles
Les langues disponibles
NoticeEoh-4Trads-FRENESIT-MAJ092021.qxp_Mise en page 1 29/09/2021 16:52 Page 19
F I R S T U S E
Remove the machine from its packaging and place it on a stable work surface, near to a
mains plug.
Remove the protective wrapping from the handle (carefully read the user precautions
printed on the wrapping.
Remove the pod basket (
pod (
14
) it contains. SAVE THE STARTING POD, IT WILL BE USEFUL LATER
Remove the protective wrapping from the handle (carefully read the user precautions
printed on the wrapping.
Put back the pod basket (
Rinse the water tank (
Rinse the filter (
Place the filter (
the back – see Filter replacement chapter on page 23).
Then:
1 - Fill the tank with fresh water ( ).
2 - Plug in the power cable (
3 - The central light (
and then go out. The machine is now on stand-by.
4 - Press coffee button ( ) or ( ) to start heating (both coffee buttons flash).
5 - When the machine reaches the required temperature, the two coffee buttons (
and ( ) will stay ON steady.
4
6 - Use the starter pod (
basket ( ).
7
7 - Pull on the machine handle ( ) to maximum while lifting to reveal the pod slot.
8 - Insert the starter pod (
9 - Push the handle (
You will need a container with a capacity of 0.5 l or more for the following operations.
Place this container under the machine coffee spout to catch the rinsing liquid.
10 - Press the Large Coffee button ( ). The light on the selected button will flash slowly
and the other button will go out. Initial rinsing will start. Rinsing will stop automatically
at the end of the cycle.
Repeat the operations twice to finalise rinsing.
11 - After the machine has been rinsed, raise the handle as far as possible (
towards you, the starter pod (
starter pod (
14
dispose of the liquid in the container used to catch the rinsing liquid. Refit the pod Basket
(
7
) en place.
After the machine has been rinsed, it can be used normally.
NOTE: If the machine is not used for more than 48 hours, we recommend repeating
steps 1 to 11 of this section.
) from the machine and remove the filter (
7
7
), the strainer (
6
) and tank lid (
12
) with tap water.
) in the water tank ( ), in the slot provided for this purpose (push right to
6
12
6
13
).
2
) will display 3 colours (blue, white and red) one after the other,
3
4
) provided with your machine, previously collected in the pod
14
1
14
), whatever side, in the slot and check positioning.
1
) towards the control buttons until completely closed.
4
14
) will then fall into the used pod basket ( ). Pick up the
) and save for later use, dispose of the liquid in the pod Basket (
9
), and the strainer grid (
) with tap water.
5
) and the starter
12
10
).
3
)
1
) while pulling
7
7
), and
18
Publicité
