Compliance - Hunter CELL-KIT Guide D'installation

Compliance

Product Specifications
Cellular Communication Module power supply: 24 VAC
from host ICC2 Controller
Cellular connection: LTE-M (Cat-M1); NB-IoT
Cellular modem carrier approvals:
• AT&T End-Device Certified (LTE-M)
• Verizon End-Device Certified (LTE-M)
• Bell End-Device Certified (LTE-M)
• Telus End-Device Certified (LTE-M)
• Compatible with other carriers offering LTE-M/NB-IoT
services
Cellular bands supported:
• 1, 2, 3, 4, 5, 8, 12, 13, 18, 19, 20, 25, 26, 28, and 39
8
Compliance
FCC:
This device complies with part 15 of the FCC Rules. Operation is
subject to the following two conditions:
1. This device may not cause harmful interference.
2. This device must accept any interference
received, including interference that may
cause undesired operation.
This equipment has been tested and found to comply
with the limits for a Class B digital device pursuant to
Part 15 of the FCC Rules. These limits are designed to provide
reasonable protection against harmful interference in a
residential installation. This equipment generates, uses, and can
radiate radio frequency energy and, if not installed and used in
accordance with the instructions, may cause harmful interference
to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference
by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment
and receiver.
• Connect the equipment into an outlet on a circuit different
from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications not expressly approved by Hunter
Industries could void the user's authority to operate this device.
If necessary, consult a representative of Hunter Industries Inc.
or an experienced radio/television technician for additional
suggestions.
To satisfy FCC and ISED RF Exposure requirements for mobile and
base station transmission devices, a separation distance of 10"
(25 cm) or more should be maintained between the antenna of
this device and persons during operation. To ensure compliance,
operation at closer than this distance is not recommended. The
antenna(s) used for this transmitter must not be co-located or
operating in conjunction with any other antenna or transmitter.