Energy Take Classic 2 Pack Mode D'emploi page 4

reCOMMenDaTIOnS
RECEIVER SETTINGS
The recommended setting for the front, rear and center speakers is the "small"
position.
AMPLIFIER REQUIREMENTS
All ENERGY Speakers are designed to operate on a wide range of receivers and/
or amplifiers. The impedance for all models is rated at 8 ohms, allowing almost
any amplifier to function well. Of course, the better the amplifier and the system
components, the better the overall system will sound.
Warning: If an amplifier or receiver is over-driven, the resulting distortion is actu-
ally many times greater than its rated power. Over-driven amplifier distortion is
called "Clipping", easily identified by its fuzzy, distorted sound, and can damage
any speaker. The volume control of most amplifiers and receivers is a logarithmic
type, which means that full power may be reached with the volume control set
at as little as the halfway point. Operating the loudness, treble, or bass controls
increases power output well beyond rated levels. The warranty on your speakers
is therefore void if the voice coils are burned or damaged as a result of overpow-
ering or clipping.
fCC anD CanaDa eMC COMPLIanCe InfOrMaTIOn:
NOTE: This equipment has been tested and found to comply with the limits for
a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference in a
residential installation. This equipment generates, uses and can radiate radio
frequency energy and, if not in-stalled and used in accordance with the instruc-
tions, may cause harmful interference to radio communications. However, there
is no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged
to try to correct the interference by one or more of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to
which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Approved under the verification provision of FCC Part 15 as a Class B Digital Device.
Caution: Changes or modifications not expressly approved by the manufacturer
could void the user's authority to operate this device.
THIS CLASS B DIGITAL APPARATUS COmPLIES WITH CANADIAN ICES-003.
CET APPAREIL NUméRIqUE DE LA CLASSE B EST CONFORmE à LA NORmE
NmB-003 DU CANADA.
eu COMPLIanCe InfOrMaTIOn:
Eligible to bear the CE mark, Conforms to European Union EmC Directive
2004/108/EC.
Weee nOTICe
Note: This mark applies only to countries within the European Union (EU) and Norway.
This appliance is labeled in accordance with European Directive
2002/96/EC concerning waste electrical and electronic equipment
(WEEE). This label indicates that this product should not be disposed
of with household waste. It should be deposited at an appropriate
facility to enable recovery and recycling.
Energy and the Energy logo are registered trademarks of Audio Products Interna-
tional Corp., registered in the U.S. and other countries. Audio Products Interna-
tional Corp., a wholly owned subsidiary of Klipsch Group, Inc., is a wholly owned
subsidiary of Voxx International Corporation.