Epson BrightLink 475Wi Guide D'installation page 60

When all of the dots have disappeared, press the
step 13.
If any dots remain (as shown below), do the following:
•
Remove any obstacles from around the projected screen. When you are finished, press the
button on the remote control and repeat step 12.
•
If the dots still remain after removing obstacles, turn the adjustment dials about a quarter turn
counterclockwise. Next, press the
•
If the dots still remain or there are obstacles that cannot be removed, such as whiteboard trays or
frames, go to step 13.
13. If there is an obstacle that cannot be removed, such as a whiteboard tray or frame, remove the tape
from the back of the supplied infrared deflectors and stick them to the screen so that the laser is not
reflected by the obstacle.
Make sure to stick the deflectors between the dots and the obstacle and adjust the number of
deflectors according to the number of dots.
❏
Do not remove an infrared deflector once it has been stuck in place.
❏
Do not stick tape or place anything on the infrared deflectors. The deflectors will
not function properly if anything is placed on them.
After placing the infrared deflectors, press the
repeat step 12.
If the dots do not disappear even after attaching the infrared deflectors, turn the adjustment dials
about a quarter turn counterclockwise. Next, press the
and then repeat step 12
If the dots do not disappear even after performing the above procedures, contact Epson.
or
again.
60
button on the remote control and then go to
button on the remote control and repeat step 12.
or button on the remote control, and then
or button on the remote control,
or