Epson BrightLink 475Wi Guide D'installation page 39

H
Attach the projector to the wall mount
1. Loosen the two screws with a Phillips head screwdriver and remove the cable cover from the projector.
Screws (x2)
2. Insert the slide plate into the wall mount from the interface side of the projector (
Align the 3-axis adjustment unit with the slide plate's alignment mark (
3. Tighten the M4 × 12 mm hexagon socket head cap bolts (×2) (
Slide plate
Projector
interface side
Spring washer
M4 × 12 mm hexagon socket head cap bolts
Warning
When installing or adjusting the wall mount, do not use adhesives to prevent the screws from
loosening and do not use lubricants or oils on the projector slide plate. This may cause the case
to crack and the projector to fall, resulting in personal injury or property damage.
Washer
39
Cable cover
).
).
Bolt positions
Alignment marks
).