Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
When the diagonal image size is less than 75 inches, mount the 3-axis adjustment unit at the position marked
with a
stamp.
Distance from projection surface to wall plate
The distance (c) from the projection surface to the bottom mounting holes on the wall plate is the number
given when the vertical slide is set to the base position, as shown below.
Match the notch on the wall mount to the position of the stamp on the wall plate.
Installation measurement tables
Use the following table to determine which installation measurement table to use for your projector.
BrightLink Pro 1410Wi/1420Wi/1430Wi
BrightLink 475W/485W/575Wi/585Wi/595Wi
BrightLink 575Wi+/585Wi+/595Wi+
PowerLite 475W/485W/575W/585W
BrightLink 480i
PowerLite 470/480/570/580
The measurements may differ depending on the location where you place the
projector.
When projecting in Tele, the quality of the projected images may decrease.
When using a WXGA projector to project images at a 4:3 aspect ratio, the images are
resized automatically and the quality of the projected images may decrease.
When the wall plate cover extender is installed, the minimum diagonal image size is
increased to: WXGA 67" (16:10), 65" (16:9), 59" (4:3); XGA 62" (4:3), 57" (16:9),
59" (16:10).
Projector model
Notch on mount arm
Maximum image
size (diagonal)
100
93
20
Base position
Stamp on plate
Installation
measurement table
WXGA
XGA
Publicité
Table des Matières
