The Led Display - Lenz Digital plus LV103 Mode D'emploi

 You have 15 seconds to program the value 93 for activating the
RailCom function into CV7. The LED will shine constantly and
RailCom is activated.
If you want to deactivate RailCom (i.e. disable the blanking interval
(cutout)), proceed as follows:
 Change to "PoM"
 Select CV7
 Program
the
LZV100/LZV200/LV103 into setting mode; again, the LEDs show a
double-flash.
 You have 15 seconds to program the value 92 for deactivating the
RailCom function into CV7. Again, the LED will shine constantly
and RailCom is deactivated.

10 The LED display

The various operating statuses of the LV103 are indicated by the LEDs
on the front plate:
LED shines constantly Everything ok, device in normal operation
LED flashes slowly
LED flashes quickly
LED double-flashes:
value 50 into
Terminals C and D are not connected
or
Emergency stop, track voltage switched off at
an operating device
or
The command station is not ready for
operation
Emergency stop, track voltage switched off
or
Overheating of amplifier
A programming procedure was started by
means of PoM (see "Setting the track
voltage")
CV7. This switches
27
E
the