Trebs 99284 Mode D'emploi page 16

2. The device
3. Before first use

After unpacking the blender, wash everything except the blender base warm, soapy water. Dry
thoroughly. Wipe the blender base with a damp cloth or sponge. DO NOT IMMERSE THE BLADE
BASE IN WATER. Care should be taken when handing the blade, as they are very sharp.

All parts of the blender are to be thoroughly cleaned before being used for the first time (see
Section: Cleaning).
4. Use your smoothie to go
1. Place the bottle on a flat surface with the open end facing up. Fill the bottle (2) with your
favorite foodstuff .Be sure not to fill ingredients past the 600mL marking.
2. Fasten the blade assembly (3)on the open end of the bottle. and tune it in clockwise direction
until it is locked.
3. Turn the bottle upside down. Line up arrows on the blade assembly to the arrows on the
blender base (5), and place the bottle in the blender base (5). Hold the on/ off button (4) to start
the blending. Release the on/ off button (4) to stop the blending.
4. Turn the bottle over and place on a flat surface. Replace the blade assembly(3) with the
drinking lid(1). Take the bottle with you throughout the day to stay hydrated.
TIP: After you've consumed your blended beverage, Wash out the bottle and reuse it throughout the
day for water or other cold liquids.
Note: For optimal performance, place desired ingredients in the bottle according to the following
order: Liquids, fresh ingredients, frozen fruit, yogurt and ice cream.
1. Drinking lid
2. Bottle
3. Blade assembly
4. On/ Off button
5. Blender base