Hilti UH 700 Mode D'emploi Original page 14

3.5 Application with hammer action
Application with hammer action
Hammer drilling in masonry
3.6 Applications without hammer action
Applications
Drilling in metal
Drilling in wood
Mixing emulsion paint
thin cement mortar,
tile adhesive,
gypsum plaster with mixing pad-
dle
4 Technical data
For details of the rated voltage, current, frequency and/or input power, refer to the power tool's
country-specific type identification plate.
If the tool is powered by a generator or transformer, the generator or transformer's power output must be
at least twice the rated input power shown on the rating plate of the tool. The operating voltage of the
transformer or generator must always be within +5 % and -15 % of the rated voltage of the tool.
Speed in 1st gear
Speed in 2nd gear
Maximum torque, 1st gear
Maximum torque, 2nd gear
Impact speed
6 English
Tool type
Cylindrical-shank drill
bits
with carbide cutting
edge
Tool type
Cylindrical-shank drill
bits
Stepped drill bits
Twist drill bits
Forstner bits
Hole saws
Auger bits
Spade bits (not self-
tapping)
TE-MP 80
TE-MP 110
UH 700
900 /min
(15.0 Hz)
2,500 /min
(41.7 Hz)
80 Nm
(59 ftlb
29 Nm
(21 ftlb
40,000 Nm
(29,502 ftlb
Dimensions Dimensions, ham-
mer drilling
1st gear/2nd gear
— ≤ 16 mm
(≤ 0.6 in)
Dimensions Dimensions
1st gear 2nd gear
≤ 13 mm 1.5 mm ... 8 mm
(≤ 0.5 in) (0.06 in ... 0.3 in)
≤ 35 mm ≤ 8 mm
(≤ 1.4 in) (≤ 0.3 in)
≤ 30 mm ≤ 30 mm
(≤ 1.2 in) (≤ 1.2 in)
≤ 45 mm ≤ 40 mm
(≤ 1.8 in) (≤ 1.6 in)
≤ 80 mm ≤ 40 mm
(≤ 3.1 in) (≤ 1.6 in)
≤ 30 mm —
(≤ 1.2 in)
≤ 40 mm ≤ 40 mm
(≤ 1.6 in) (≤ 1.6 in)
In 1st gear —
recommended
In 1st gear —
recommended
)
f
)
f
)
f
273762
*273762*