Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
6.10
Inserting accessory tool into keyed chuck
1. Open the keyed chuck until you can insert the shank of the accessory tool.
2. Insert the accessory tool.
3. Close the keyed chuck by turning the gear ring.
4. Insert the chuck key into one of the holes in the keyed chuck.
5. Secure the accessory tool by turning the chuck key clockwise.
6. Remove the chuck key.
6.11
Removing accessory tool from keyed chuck
1. Insert the chuck key into one of the holes in the keyed chuck.
2. Turn the chuck key counter-clockwise to open the chuck.
3. Remove the accessory tool.
4. Remove the chuck key.
7
Types of work
WARNING
Damaged power cords are a safety hazard! If the supply cord or extension cord is damaged while work
is in progress, immediately disconnect the device and the cord from the electricity supply. Do not touch the
damaged part of the cord.
▶ Regularly check all supply cords. Replace defective extension cords. Have damaged power cords
replaced by a qualified specialist.
Use of a ground fault circuit interrupter (residual current device, RCD) with a maximum tripping current of
30 mA is recommended.
7.1
Switch sustained operation on and off
1. Press the control switch and hold it in this position.
2. Press and hold down the lockbutton.
3. Release the control switch.
4. Release the lockbutton.
5. To switch off continuous operation, press the control switch and then release it.
7.2
Control switch with electronic speed control
Speed can be controlled steplessly right up to maximum by varying how far the control switch is pressed in.
7.3
Setting forward or reverse rotation
CAUTION
Risk of damage Actuation while the tool is running may result in damage to the gearing.
▶ Do not operate the forward / reverse switch while the motor is running.
▶ Set the forward/reverse switch to the desired direction of rotation.
7.4
Hammer drilling
▶ Set the function selector switch to hammer drilling:
It might be necessary to turn the spindle slightly.
7.5
Drilling, 1st and 2nd gears
▶ Set the function selector switch to position 1, "Drilling in first gear" or position 2, "Drilling in second gear".
It might be necessary to turn the spindle slightly.
*273762*
11
12
13
14
273762
9
10
.
English
9
Publicité
Table des Matières
