-Picture 3-
! WIDTH: 100 cm
! DEPTH: 47 cm
! HEIGHT: 63 cm
" Remove the power mower from its packing.
" " " " Fix the handles to the handlebar support using the two screws and two knobs pre-mounted on the handle. Make sure to
position the control cables correctly.
" " " " Fix the bar to the machine, by unspitting the spring (Picture 9 Ref. A) on the pin Ref. B. Thread the pin in the casing Ref. C
and thread the spring again (Ref. A). Take the little plastic cylinder (Picture 9 Ref. D), threat it in the grass divider head Ref.
E and threat all in the pin of the lever arm Ref. F, in the holes on the head and on the cylinder. Fix the head Ref. E to the
bar by screwing two screws Ref. G in the threaded holes on the bar.
" " " " If the machine is to be transported, empty out the petrol tank and always apply the plastic protective strip to the cutting bar
blade. If E.S.M. type, please read the sheet enclosed.
IMPORTANT: THE PACKED MACHINE IS SUPPLIED WITH THE MOTOR WITHOUT OIL OR PETROL.
•
Read carefully the operation and maintenance manual enclosed with the machine.
•
The use of the machine is prohibited to persons under 16 years of age.
•
The operator is liable for damages since the machine is under his control.
•
Those unfamiliar with the machine or who have never used it are obliged to read the operation and maintenance manual
before operation.
•
In case of transport, disassemble the bar and empty the petrol out of the tank.
•
If the machine is left unattended, ensure that it cannot start up again.
•
Before running the machine, the operator must have a 5 meter radius of free space around him.
•
Dry any petrol leaks.
•
Fill up the tank with the motor off. Filling the tank or transferring fuel must always be performed outdoors, away from flames
or heat sources. Do not smoke during this operation.
•
When mowing in mountainous areas or on slopes, mow horizontally and use non-skid equipment on shoes and wheels.
•
If the blade needs replacement, observe E.S.M. operation and maintenance procedures.
•
If the bar suffers impact, check the condition of the bar before resuming work.
•
Keep feet and hands far away from the cutting bar and all rotating parts.
•
Do not run the motor where exhaust containing carbon monoxide may accumulate.
•
Never use the mower incomplete or without its safety device.
8
!!
!
!
PACKING AND TRANSPORT
SAFETY RULES
-Picture 4-
!